[QuickTacBeta] Problem with VersaPoint print out

[Peter Sullivan]

Lisa,

I don't have any idea what might be causing this, unless perhaps we're
setting the page length incorrectly.  What you're seeing might be the
VersaPoint's effort to skip a perforation.

Unfortunately, neither of our two VersaPoints is in working order, so I
cannot try it for myself.

But if you send me a copy of a file printed-to-disk, I can make an effort to
analyze it.

You might also just try changing the paper size in QuickTac's page setup to
see whether that affects the placement of the gaps at all.  If it does, then
this at least lends some credence to the page length theory.

Best Regards,

Peter

-----Original Message-----
From: quicktacbeta-bounces at duxsys.com
[mailto:quicktacbeta-bounces at duxsys.com] On Behalf Of Lisa Yayla
Sent: Wednesday, May 23, 2007 11:03 AM
To: quicktacbeta at duxsys.com
Subject: [QuickTacBeta] Problem with VersaPoint print out

Hi,
This is an embosser set up question. I'm using VersaPoint and when embossing
out get gaps of about 8 inches.
That is the embossing stops and begins again after about 8 inches of empty
area.And the fill is irregular when embossed out.
Any ideas?

Thanks,
Lisa


Lisa Yayla
Huseby Kompetansesenter
Oslo Norway
lisa.yayla at statped.no