[QuickTacBeta] QuickTac and VersaPoint question

[George Bell]

Hi Lisa,
 
Is it possible that a combination of top and bottom margin,
and perhaps even a blank area top and bottom of the graphic
could be the cause?
 
Is the embosser working OK where braille in concerned?
 
George.

________________________________

From: quicktacbeta-bounces at duxsys.com
[mailto:quicktacbeta-bounces at duxsys.com] On Behalf Of Lisa
Yayla
Sent: Friday, May 25, 2007 9:55 AM
To: accessibleimag at freelists.org; quicktacbeta at duxsys.com
Subject: [QuickTacBeta] QuickTac and VersaPoint question


Hi,

I have a question about using a VersaPoint and QuickTac
betaversion and hoping someone might have an idea.
When printing out a graphic directly from QuickTac the
picture  divides into parts. First a bit of the graphic
embosses than it spaces down for about 5 inches then
embosses a bit then spaces again etc.
I think this is a hardware/firmware problem but not sure.
Any ideas? Any help would be appreciated.

Thanks,
Lisa

Lisa Yayla
Huseby Kompetansesenter 
Oslo Norway
lisa.yayla at statped.no

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailserver.duxsys.com/pipermail/quicktacbeta/attachments/20070525/f0302fde/attachment.htm