[QuickTacBeta] QuickTac & Interpoint

[Peter Sullivan]

Marshall,

Perhaps you could clarify.  Which of the following best describes what is
going on?

1. DBT places the graphic on the front side of the sheet and always leaves
the back blank.

2. DBT places the graphic on the front side of one sheet, then leaves the
back of that sheet and the front of the next blank.

3. DBT places the graphic on the front side of one sheet, then leaves the
back of that sheet and both sides of the following sheet blank.

- Peter

-----Original Message-----
From: quicktacbeta-bounces at duxsys.com
[mailto:quicktacbeta-bounces at duxsys.com] On Behalf Of Bautista Jr, Marshall
Sent: Tuesday, July 01, 2008 12:36 PM
To: quicktacbeta at duxsys.com
Subject: [QuickTacBeta] QuickTac & Interpoint

Greetings all,
    we would like to know if someone has a solution to our problem...
 
Dux 10.7 / QT 4 / Enabling Technologies
 
When we insert a QT graphic into an interpoint document, our embosser is
leaving a blank page immediatly following the graphic.
 
-Marshall

________________________________

(i) This e-mail and any files transmitted with it are confidential and
intended solely for the use of the intended recipient(s). If you have
received this e-mail in error, please notify the sender immediately and
delete this e-mail and any associated files from your system. (ii) Views or
opinions presented in this e-mail are solely those of the author and do not
necessarily represent those of Corrections Corporation of America. (iii) The
recipient should check this e-mail and any attachments for the presence of
viruses. The company accepts no liability for errors or omissions caused by
e-mail transmission or any damage caused by any virus transmitted by or with
this e-mail. This email has been scanned for content and viruses by the
CipherTrust Email Security System.